Type Here to Get Search Results !

How to Reset the drive and Start up Parameter of Allen Bradley VFD

In this article, we are going to learn how to reset the allen bradley variable frequency drive (vfd). How can we reset allen bradley variable frequency drive (vfd) to factory default setting. You know, when you purchase a drive, it has pre-loaded parameters which are called factory settings, which manufacturer loads in allen bradley variable frequency drive (vfd). That is also mentioned in the manual of allen bradley variable frequency drive (vfd) alright that is called factory setting.


Because many times, when you go to program a drive, take out a drive from different panel and you are going to use that in different panel for other exercise and other process. You need to go to the factory reset setting. Because you do not know what are the parameter, which is already installed into the drive. So in that case, what we do? We wash all the parameter to factory setting.


To do that, there are some default parameters, which we use that parameter to make the drive in factory setting. Following are parameter to make it in factory default. There are two steps to do that.

Step 1: Reset the drive to factory setting.

Go to parameter setting. In p112. This p112 is reset to default parameter, which means we use this parameter 112 to reset the drive to factory setting.  Resets all parameter values to factory defaults. After tha reset function is complete, this parameter will set itself back to "0". By entering value "1" in p112, it will do the drive in factory setting.

Step 2: Enter motor related parameters

P101 – motor np voltage
Stop drive before changing this parameter.
Set to the motor nameplate rated voltage.

P102 – motor np hertz.
Stop drive before changing this parameter.
Set to the motor nameplate rated frequency.

P103 – motor ol current.
Set to the maximum allowable motor current.

P104 – minimum frequency.
Sets the lowest frequency the drive will output continuously. Min/max: 0.0/400.0 hz.

P105 – maximum frequency.
Sets the highest frequency the drive will output continuously. Min/max: 0.0/400.0 hz.

This methods are for switching your allen bradley powerflex 4m variable frequency drive in factory setting.


Post a Comment

0 Comments